Qualification Of The Operator; Preparation For Assembly - Tecnoma VECTIS 800e Adjustments, Use And Maintenance

– COMMISSIONING THE MACHINE –
IMPORTANT
Respecting the following values is the condition to be satisfied before the tractor is used with
your machine coupled.
Check the following points:
• The authorised thrust load on the coupling device of the tractor must be adequate as regards
the load actually present.
• The loads per axle and the weight of the tractor modified by the thrust load must be lower than
the authorised limit values. If in doubt, have it check-weighed.
• The actual static load on the rear axle of the tractor must be less than the authorised load for
this axle.
• The GVWR for the tractor must be respected.
• The authorised load capacities of the tyres of the tractor must not be exceeded.

4.2.3 - QUALIFICATION OF THE OPERATOR

The machine must only be prepared by a person qualified to carry out the operations listed in chapter
COMMISSIONING THE MACHINE
IMPORTANT
Before commissioning the machine, the user must first read and understand the instructions.

4.2.4 - PREPARATION FOR ASSEMBLY

WARNING
Risks of accidents due to impacts, crushing, cutting, jamming and seizure in the zone where
the hydraulic or electrical parts operate.
Do not block the controls on the tractor used to directly command the parts such as the folding /
unfolding, pivoting, sliding, etc.
Open the main tank cover.
• Remove the various parts and accessories inside the sieve
unit.
• Read the instructions
Tecnoma
authorised distributors stamp on the page-chapter
IDENTIFICATION OF THE MACHINE
• Complete the
best practices charter and follow the instructions for return to
Tecnoma
.
• Take the unit supports, electrical cables , etc... required
for the final assembly of the machine (see paragraph electrical
connections below.
fully and
warranty certificate, the
stamp with your
"Phytomieux"
MAy-2015
Fig.4
43