Tecnoma VECTIS 800e Adjustments, Use And Maintenance page 48

– COMMISSIONING THE MACHINE –
WARNING
Danger of tipping over and crushing by the machine.
• Use the equipment provided to couple the tractor - machine assembly appropriately.
• Each time when coupling, visually check that the coupling parts are in good condition.
• Use the locking systems.
• Visually check the coupling and the locks before starting up.
WARNING
Danger of power failure between the tractor and the machine after damage to the flexible supply
pipes.
When connecting the flexible feed pipes, ensure that they can follow all of the movements of the
machine, without tension or rubbing.
4.2.7.1 Moving the stand
Read the "Stand" paragraph in chapter USING THE MACHINE of this manual.
4.2.7.2 Hitch
IMPORTANT
Connect the flexible hydraulic feed hoses before coupling the machine.
1. Position the lower arms
A
coupling rods
2. Move the tractor back until it can be coupled.
3. Start by coupling the ball joint of the LH arm onto the matching rod.
4. Then couple the RH arm using if required its height adjustment. Secure the lower arms with the
G
safety pins (1).
5. Slightly lift the arms to "separate" the stand from the ground (2)
B
1
Fig.10
A
G
C
B
of the sprayer hitch.
Fig.8
A
G
of the hydraulic raiser substantially at the same height as the
2
A
3
MAy-2015
Fig.9
Fig.11
48