Tecnoma VECTIS 800e Adjustments, Use And Maintenance page 24

Table of Contents

Advertisement

– GENERAL SAFETy –
3.8 - MODIFICATIONS TO THE MACHINE
WARNING
Danger or risk by electrocution, crushing, cutting or entrapment due to the breakage of load-
bearing parts.
No modifications or conversions of any sort are allowed without the authorisation of 
including mechanical and welding modifications.
3.9 - ENVIRONMENTAL PROTECTION
Please read the corresponding chapter at the end of this manual.
3.10 - WARNING PICTOGRAMS AND OTHER MARKINGS
IMPORTANT
Check that the warning pictograms are present and clean.
Replace illegible or missing pictograms by ordering them from your reseller (remember to note the
reference, e.g., 5319909)
You will find the pictogram references used on your machine in chapter  MACHINE DESCRIPTION
.
3.10.1 - DESCRIPTION OF WARNING PICTOGRAMS
A warning pictogram indicates an area of potential danger on an apparatus, as well as the risks incurred.
A warning pictogram has two sections
ZONE THAT DESCRIBES THE RISK INCURRED IN
THE FORM OF AN ILLUSTRATION FRAMED WITHIN
A SAFETy TRIANGLE
A SECTION THAT DISPLAyS THE RECOM-
MENDATION WHICH ENABLES THE RISK
TO BE AVOIDED
reference to the pictogram
MAy-2015
Tecnoma
,
24

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the VECTIS 800e and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Vectis 1000eVectis 1000Vectis 1200

Table of Contents