Tecnoma VECTIS 800e Adjustments, Use And Maintenance page 20

– GENERAL SAFETy –
IMPORTANT
TOWED MACHINES
• If your machine is equipped with an articulated drawbar or a steering/levelling axle, make sure it is locked in
the road position. Refer to chapter MACHINE USE
• If your machine is equipped with AXAIR suspension, do not drive the sprayer with deflated bellows. Refer to
chapter COMMISSIONING THE MACHINE for the bellow inflation procedure
• Completely release the parking brake
3.6.6 - TRANSPORT ON A TRUCK
IMPORTANT
TOWED MACHINES
• To ensure the stability of a sprayer equipped with AXIAR suspensions when being transported
on a truck or low loader, deflate the two bellows using the procedure described in chapter
COMMISSIONING THE MACHINE
3.6.7 - BEFORE GETTING OFF THE TRACTOR
Take all precautionary measures to avoid accidental starting and/or movement of the tractor:
1. Immobilise the machine on a flat surface
2. Lower the machine to the ground
3. Put the parking brake on
4. Stop the engine and remove the key from the ignition
5. Use chocks when parked on a slope
3.6.8 - OTHER RISKS
3.6.8.1 Overhead power lines
• Make sure that the clearance in relation to the machine is sufficient whenever the machine is operated (for
example the maximum boom height with the back hatch open)
• Also remember the radio aerial and all other original or other installed accessories
• If the machine comes into contact with a power line, stop the machine and the tractor's engine immediately
and apply the parking brake
• Check whether you can leave your current position without touching the electric lines, then jump from your
position so that there is no simultaneous contact between your body and the machine and the ground while
dismounting.
• Stay well clear of the machine until the power lines are powered down.
• Warn all persons near the machine of the danger.
• Ask for the line to be powered down
3.6.8.2 Electric batteries
The batteries contain sulphuric acid. In the event of contact with the skin, rinse thoroughly with clean water and
consult a doctor.
3.6.8.3 Hydraulic circuits
• Regularly check that the hydraulic circuits are in good working order.
• In the event of injury caused by the hydraulic oil, immediately consult a doctor.
• For machines without a hydraulic control unit
MAy-2015
20