Filtering Component Types And Sizes; Instructions For Maintenance; Types Of Pesticides Likely To Affect Sprayer Efficiency; Products That May Cause Failure Of The Sprayer - Tecnoma VECTIS 800e Adjustments, Use And Maintenance

– ENVIRONMENTAL PROTECTION –

7.3.2 - FILTERING COMPONENT TYPES AND SIZES

Basic equipment for sprayer
• Suction (365µ or 594µ for liquid fertiliser)
• Filling sieve (500µ)
• Filter on pressure gauge (500µ)
• Filter (365µ) on LAV'TON system (if present)
• Section filter (fitted according to type of spraying: 365µ as standard)
• Filtration of spray nozzles: please refer to boom user guide.
Frequency of inspections
COMMENTS
your approved Tecnoma dealer has all the instruments required to carry our regular checking of your
sprayer.
IMPORTANT
Check the sprayer by carrying out a calibration:
IMPORTANT
Refer to paragraph "GENERAL CHECKS" in chapter VII MACHINE USE

7.4 - INSTRUCTIONS FOR MAINTENANCE

IMPORTANT
• Read the paragraphs regarding daily maintenance, periodical inspections and wintering in
section "OVERALL SPRAyER MAINTENANCE" in chapter VIII
sprayer's user guide.
• Ensure that all the filters used on your sprayer are clean and correctly installed.

7.5 - TyPES OF PESTICIDES LIKELy TO AFFECT SPRAyER EFFICIENCy

7.5.1 - PRODUCTS THAT MAY CAUSE FAILURE OF THE SPRAYER.

Take special care when using the following products:
• Soluble powder → Risk of obstruction of nozzles, filters, etc.
• Xylene-based products → This component can cause rapid deterioration of seals.
◊ before the start of the spraying campaign
◊ if there are discrepancies between the spraying pressure actually displayed and the required
spray pressure according to the spray screen.
May-2015
MACHINE MAINTENANCE in your
125