Table of Contents
Advertisement
6-13-6.
DC Fan (40) (HPR-55 Board Assembly)
Preparation
1.
Remove the control panel assembly. (Refer to
2.
Remove the top plate assembly. (Refer to
3.
Remove the bottom plate. (Refer to
4.
Remove the HPR board assembly. (Refer to
Procedure
1.
Open the two clamps and disconnect the harness from the connector (CN2601) on the HPR-55 board.
2.
Remove the two screws to detach the DC fan (40 square).
DC fan (40 square)
Note
Install the DC fan (40 square) carefully paying attention to the label side and the harness position.
3.
Install the removed parts by reversing the steps of removal.
PDW-HD1550
"6-2-1. Control
"6-3. Top Plate
"6-4. Bottom Plate
"6-13-1. HPR Board
Label
Panel")
Assembly")
Assembly")
Assembly")
Clamps
PSW2.6 x 6
Harness
Harness
CN2601
(HPR-55 board)
6-63
Advertisement
Table of Contents
