Hpr-23 Board, Enc-107 Board - Sony PDW-HD1500 Maintenance Manual

6-12-9. HPR-23 Board, ENC-107
Board
Removal
1. Remove the top panel assembly and the
bottom plate assembly.
(Refer to Sections 1-4-1 and 1-4-4.)
2. Remove the IF-1073 board.
(Refer to Section 6-12-8.)
3. Remove the KY cable plate (GND) from the
chassis.
4. Disconnect the flexible card wire from the
connector CN2101, and disconnect the
harness from the connectors CN2109 and
CN2 to remove the flexible card wire outside
through the hole of the chassis.
5. Disconnect the harnesses from the connectors
CN1 and CN3.
6. Remove the four screws.
7. Disconnect the four board-to-board connec-
tors connecting the MB-1113 board to the
HPR-23 board. Detach the HPR-23 board in
the direction shown by the arrow.
PDW-HD1500/V1 (E)
Hole of chassis
HPR-23 board
CN3
CN3
Hole of chassis
Four connectors
(board to board)
Four connectors
of MB-1113 board
Flexible card wire
Harnesses
PSW2.6 x 6
Flexible card wire
CN2101
KY cable plate
CN1
CN2109
HPR-23 board
CN2
(GND)
6-25