Note
• When installing the heat sink, fit the two bosses with the two holes in the heat sink.
• When installing the heat sink, arrange the fan harness and the harness POWER (SYS) as shown in the figure.
• When installing the heat sink, do not place inclusion with the heat gel between the heat sink.
Fan harness
Harness POWER (SYS)
4.
Disconnect the five flexible boards and two harnesses from the seven connectors on the BD-42 board.
5.
Remove the heat gel.
Note
Do not damage the heat gel.
PDW-HD1550
SY-400 board
Heat sink
6-33