6-13-4.
Fine-Wire Coaxial Cable
Preparation
1.
Remove the control panel assembly. (Refer to
2.
Remove the top plate assembly. (Refer to
3.
Remove the bottom plate assembly. (Refer to
4.
Remove the HPR board assembly. (Refer to
Procedure
1.
Remove the fine-wire coaxial cable.
(1) Disconnect the fine-wire coaxial cable from the connector (CN4) on the HPR board.
(2) Open the two clamps and remove the fine-wire coaxial cable.
HPR board
Note
When installing, arrange the fine-wire coaxial cable as shown in the figure.
2.
Remove the ferrite core.
Ferrite core
Binding tape (S)
Note
When replacing the fine-wire coaxial cable, set the ferrite core as shown in the figure.
3.
Install the removed parts by reversing the steps of removal.
PDW-HD1550
"6-2-1. Control
"6-3. Top Plate
"6-4. Bottom Plate
"6-13-1. HPR Board
CN4
Fine-wire coaxial cable
Binding tapes (L)
Panel")
Assembly")
Assembly")
Assembly")
Fine-wire coaxial cable
Clamps
Binding tape (S)
6-58