Table of Contents
Advertisement
6-7-16.
SE-1005 Board
Preparation
1.
Remove the top plate assembly. (Refer to
2.
Remove the optical drive assembly. (Refer to
3.
Remove the IF-1240 board. (Refer to
4.
Remove the optical drive (XDD-P210). (Refer to
5.
Remove the loader assembly. (Refer to
Procedure
1.
Disconnect the FPC SE 1005-LDR36 board from the connector (CN36) on the SE-1005 board.
2.
Disconnect the flexible cable from the connector (CN2) on the SE-1005 board.
3.
Remove the five screws (P1.7 x 2.5) to detach the SE-1005 board.
Note
• When installing the SE-1005 board, fit the seven bosses with the seven holes in the SE-1005 board.
• Install the FPC SE1005-LDR36 with the stiffening plate facing up.
SE-1005 board
4.
Install the removed parts by reversing the steps of removal.
PDW-HD1550
"6-3. Top Plate
Assembly")
"6-7-1. Optical Drive
"6-7-3. IF-1240
Board")
"6-7-4. Optical Drive
"6-7-5. Loader
Assembly")
CN2
P1.7 x 2.5
Holes
Flexible cable
Bosses
Assembly")
(XDD-P210)")
Hole
CN36
Holes
Bosses
FPC SE1005-LDR36
Stiffening plate
Latch
6-41
Advertisement
Table of Contents
