6-13.
HPR Section
6-13-1.
HPR Board Assembly
Preparation
1.
Remove the control panel assembly. (Refer to
2.
Remove the top plate assembly. (Refer to
3.
Remove the bottom plate assembly. (Refer to
Procedure
1.
Remove the front panel sub assembly.
(1) Remove the two screws to detach the CP shield assembly.
(2) Remove the two screws.
(3) Release the two claws to detach the front panel sub assembly.
Claw
Front panel sub assembly
Note
When installing the front panel sub assembly, fit the USB connector with the hole of the front panel sub assembly.
PDW-HD1550
"6-2-1. Control
Panel")
"6-3. Top Plate
Assembly")
"6-4. Bottom Plate
Assembly")
PSW2.6 x 6
Claw
Note for installation
USB connector
Hole
CP shield assembly
PSW2.6 x 6
6-54