Table of Contents
Advertisement
3-1.
XDCAM Web Site Overview
You can display the settings of the unit, upgrade the firmware and do the same kinds of operations through the
NETWORK connector.
The XDCAM web site consists of the following menus.
Status menu
• Software Version
Maintenance menu
• Network
• SNMP
• Account
• Setup Menu
• Software Update
• Log
• Warning
3-1-1.
Connecting to the XDCAM Website
Tools/Equipment Required
• Personal computer (referred to as PC hereafter)
• Network cable (crossover or straight-through)
Procedure
1.
Connect the unit to the host PC using one of the following ways. (Refer to the Operation Manual)
• Connect the unit to the PC through a network device (such as a hub).
• Connect the unit directly to the PC.
2.
Start the web browser of the PC. Enter "http://192.168.1.10" in the Address bar. (The underlined part is the IP
address of the unit.)
Note
• Use Internet Explorer for the web browser of the PC.
Other web browsers may not function correctly.
• Default NETWORK of the unit has been set to DHCP ENABLE.
When specifying an IP address, set the NETWORK of the unit.
3.
Enter the User name and Password, and then click "OK".
User name
• "admin"
Password
• "pdw-hd1550"
Tip
User name and user password can be changed on the Account page.
4.
Top page of the XDCAM web site is displayed. Click a menu you want to browse on the left frame.
PDW-HD1550
Section 3
XDCAM Web Site
3-1
Advertisement
Table of Contents
