Table of Contents
Advertisement
3.
Disconnect the FPC SE1004-LDR35 from the connector (CN35) on the LDR-35 board.
Note
Carefully open or close the latch (open/close section) of CN35 because it is likely to be damaged.
FPC SE1004-LDR35
CN35
(LDR-35 board)
FPC SE1004-LDR35
4.
Disconnect the FPC SE1005-LDR36 from the connector (CN36) on the LDR-36 board.
Note
Carefully open or close the open/close section of CN36 because it is likely to be damaged.
5.
Disconnect the motor harness from the connector (CN3) on the SE-1005 board.
6.
Loosen the two screws with stopper (PSW2 x 5).
7.
Lift up the portion A to the direction of the arrow A (about 15°)
PDW-HD1550
Bracket
Latch
ME ratchet
Hole
Driver
6-19
Advertisement
Table of Contents
