Table of Contents
Advertisement
2.
Display the maintenance menu. (Refer to 4-1-2.)
3.
Select "VIDEO OUT LEVEL".
Menu hierarchy
[M1 : ADJUST]
[A2 : AUDIO/VIDEO/BATTERY]
[A20 : VPR VR]
[VIDEO OUT LEVEL]
4.
Check that level A of the white signal of COMPOSITE OUTPUT 1 output meets the specification. If level A does
not meet the specification, adjust it .
Tip
Both COMPOSITE OUTPUT 1 and COMPOSITE OUTPUT 2 (SUPER) are modified by "A20 : VPR VR" menu
at the same time.
5.
Perform the following procedure to check the COMPOSITE OUTPUT 2 (SUPER) connector output .
(1) Connect the COMPOSITE OUTPUT 2 (SUPER) connector to the analog composite waveform monitor as
shown below.
PMW
COMPOSITE
OUTPUT 2
(2) Check that level A of the white signal of COMPOSITE OUTPUT 2 (SUPER) output meets the specification.
If level A does not meet the specification, adjust it.
Note
"A20 : VPR VR" menu acts on both COMPOSITE OUTPUT 1 and COMPOSITE OUTPUT 2 (SUPER).
Make the adjustment so that both outputs meet the specification at the same time.
6.
Press the [F1 (RETURN)] button once to exit "A20 : VPR VR".
Saving the adjustment data
Perform the following procedure only when Output Level Adjustment is performed.
1.
Select "A2F : NV-RAM CONTROL" and execute "SAVE ALL ADJUST DATA".
When data has been successfully saved, "Save Complete" appears in the menu screen.
Note
To load the pre-adjustment data without saving the adjustment data, execute "ALL DATA PREVIOUS."
2.
Exit the maintenance menu.
Composite Video Output Adjustment (50 Hz Mode)
1.
Set as follows in the setup menu.
(For details, refer to the operation manual.)
Setup menu
ITEM-013 (SYSTEM FREQUENCY SELECT MENU)
PDW-HD1550
Composite
waveform monitor
75 Ω
Mode
50 Hz
8-9
Advertisement
Table of Contents
