Table of Contents
Advertisement
6-7-15.
SE-1004 Board
Preparation
1.
Remove the top plate assembly. (Refer to
2.
Remove the optical drive assembly. (Refer to
3.
Remove the IF-1240 board. (Refer to
4.
Remove the optical drive (XDD-P210). (Refer to
5.
Remove the loader assembly. (Refer to
Procedure
1.
Disconnect the FPC SE1004-LDR35 board from the connector (CN35) on the SE-1004 board.
2.
Remove the five screws (P1.7 x 2.5) to detach the SE-1004 board.
Note
• Install the FPC SE1004-LDR35 with the stiffening plate facing up.
• When installing the SE-1004 board, fit the eight bosses with the eight holes in the SE-1004.
SE-1004 board
Hole
3.
Install the removed parts by reversing the steps of removal.
Note
• Before installing a new SE-1004 board, bend it to prevent it from floating.
• After the work is completed, make skew adjustment. (Refer to
4.
Perform software settings using the menu after replacing/repairing the SE-1004 board. (Refer to
Board")
PDW-HD1550
"6-3. Top Plate
"6-7-1. Optical Drive
"6-7-3. IF-1240
"6-7-4. Optical Drive
"6-7-5. Loader
FPC SE1004-LDR35
Stiffening plate
P1.7 x 2.5
Holes
Bosses
Bosses
Assembly")
Assembly")
Board")
(XDD-P210)")
Assembly")
Hole
Holes
Boss
"7-4. SKEW
Adjustment")
Latch
CN35
"1-9-5. SE-1004
6-40
Advertisement
Table of Contents
