Ac Power Cable Using Iec C13 Inline Socket - Kongsberg Simrad EK80 Installation Manual

AC power cable using IEC C13 inline socket

This cable is used to connect any unit or device to AC mains supply. It is commercial,
and normally used for 115 and 230 VAC. The inline socket and plug comply to the
IEC60320 standard.
A IEC13 line socket - may be fitted with a locking device
B CEE 7/7 male power plug
C Live (normally identified with Blue insulation)
D Neutral (normally identified with Brown insulation)
E Ground (normally identified with Yellow or Yellow/Green insulation)
A standard commercial AC mains cable is used. The power cable is normally terminated
with an female IEC C13 inline socket. The AC mains end is terminated in an AC
connector suitable for the local standard and/or the output sockets on an uninterruptible
power supply (UPS). If this is not the case, you must replace the AC connector.
The typical cable length is between 1,5 and 2 meters. If this is too short you must use an
extension cable (not recommended), mount a new power outlet within range, or make
your own power cable with sufficient length. If you use an uninterruptible power supply
(UPS), you can also move the UPS to a different location within range.
Note
There are substantial differences between American and British nomenclature related to
power plugs and sockets. Observe local standards and regulations.
394149/D
Cable layout and interconnections
137