Kongsberg Simrad EK80 Installation Manual page 14

Simrad EK80 Installation Manual
Installation drawings
The installation shipyard must provide all necessary design and installation drawings, as
well as the relevant work standards and mounting procedures. The installation shipyard
must design and manufacture relevant installation hardware to fit each individual
hardware unit.
Note
If required, all documents provided by the shipyard for the physical installation of the
EK80 must be approved by the vessel's national registry and corresponding maritime
authority and/or classification society. Such approval must be obtained before the
installation can begin. The shipowner and shipyard doing the installation are responsible
for obtaining and paying for such approval.
The outline dimensions of the EK80 units are found in the Drawing file chapter in this
manual.
The source drawings (normally in AutoCad format) can be downloaded from our website.
• https://www.kongsberg.com/ek80
Online information
All end-user manuals provided for operation and installation of your Simrad EK80 can
be downloaded from our website.
• https://www.kongsberg.com/ek80
Our website also provides information about other Simrad products.
Registered trademarks
Observe the registered trademarks that apply.
Windows ® is a registered trademark of Microsoft Corporation in the United States and
other countries.
Simrad ® , SIMRAD ®
trademarks of Kongsberg Maritime AS in Norway and other countries.
We want your feedback
We want to improve EK80 continuously. We also want our end-user documentation to be
comprehensive and relevant. You can help. Please provide comments, suggestions or
constructive criticism to any of our support offices.
12
and the Simrad ® logo are either registered trademarks, or
394149/D