Kongsberg Simrad EK80 Installation Manual page 206

Simrad EK80 Installation Manual
In order to obtain a software license you must contact a Simrad dealer or distributor.
You can also use the request form on https://www.simrad.com/support, or contact our
support department directly.
Note
This information is only valid if your EK80 is meant to operate with one (or more) of the
following transceivers:
• Wide Band Transceiver (WBT)
• WBT Tube
• WBT Mini
• EC150-3C
Procedure
1 Obtain the necessary information about your transceiver(s) and transducer(s).
Write down:
a The serial number for each transceiver.
b The beam type.
c Which transducers you have connected to each transceiver.
2 Send the necessary information to one of Simrad's dealers or distributors.
You can also use the request form on https://www.simrad.com/support, or contact
our support department directly.
You can use the following e-mail address:
• purchase.order@simrad.com
Once the software license string(s) have been returned to you (most likely by e-mail),
you can install the licenses into the software.
3 On the menu, select
Setup
Observe that the
of pages selected from the menu on the left side.
4 On the left side of the
Observe that the
5 Select
Type License String
If you do not have a computer keyboard connected to your EK80 system, select the
button to open an on-screen keyboard. If you have received the license
Keyboard
string on an electronic format (e-mail or text file), you can copy the string from the
source document and paste it into the
204
Installation
dialog box opens. This dialog box contains a number
Installation
dialog box, select
Installation
page opens.
Software License
, and type the license string into the dialog box.
.
Software License
dialog box.
Type License String
.
394149/D