Kongsberg Simrad EK80 Installation Manual page 270

Simrad EK80 Installation Manual
The properties of each of the available communication ports are defined on the
page. The
Sensor Installation
sensors and systems. To make sure that the information from the "most reliable" sensors
are used by the EK80, use the
The communication parameters defined for NMEA 0183 are:
• : 4800 bit/s
Baud rate
• : 8
Data bits
• : Even
Parity
• : 1
Stop bits
Procedure
1 Open the
Setup
2 On the menu, select
Setup
Observe that the
of pages selected from the menu on the left side.
3 On the left side of the
a Select the relevant sensor in the
b Make sure that the correct installation parameters are used for the sensor.
4 On the left side of the
a Select the relevant sensor in the
b Make sure that the correct parameters are used for sensor configuration.
5 Close the
Installation
6 Observe the top bar.
7 Make sure that the information from the sensor is displayed.
If necessary, enable the read-out in the
8 If possible, use another instrument to verify that the information provided by the
EK80 is correct.
9 Fill in the result tables.
Result
Datagram
268
page allows your EK80 to communicate with external
Sensor Configuration
menu.
Installation
dialog box opens. This dialog box contains a number
Installation
dialog box, select
Installation
dialog box, select
Installation
dialog box without making any changes.
Port
page to define a datagram priorities.
.
Sensor Installation
list.
Installed Sensors
Sensor Configuration
list.
Sensor
dialog box.
Display Options
Baud rate
I/O Setup
.
.
Talker ID
394149/D