Kongsberg Simrad EK80 Installation Manual page 264

Simrad EK80 Installation Manual
Caution
You must never set the EK80 to "ping" unless the transducer is submerged in water.
The transducer may be damaged if it transmits in open air.
• All the relevant transceivers have been set up, and they are operational with their
respective transducers.
• All relevant channels (transceiver/transducer combinations) are installed in the user
interface.
• All relevant external sensors are connected to the EK80. The sensors are turned
on and operate normally.
• The vessel is berthed or at sea.
Procedure
1 Open the
Setup
2 On the menu, select
Setup
Observe that the
of pages selected from the menu on the left side.
3 On the left side, select
4 Make sure that all applicable transceivers and transducers are connected and
operational.
For each transceiver, this is indicated by the green label with text "Installed".
5 Repeat this cycle for each Wide Band Transceiver (WBT) in use.
a Click on the transceiver to select it.
b In the transceiver list, read the name of the transducer in use.
c In the Transceiver Information field, read the following information:
• Identity
• TX Firmware version
• RX Firmware version
• Software version
6 Fill in the result table.
7 Close the
Installation
262
menu.
Installation
dialog box opens. This dialog box contains a number
Installation
.
Transceiver
dialog box.
.
394149/D