Kongsberg Simrad EK80 Installation Manual page 253

Local connection on the Processor Unit
A
Connection on remote device
B
2 Turn on the EK80, and set it to normal use.
3 Open the
Setup
4 On the menu, select
Setup
Observe that the
of pages selected from the menu on the left side.
5 On the left side of the
6 Select
Synchronization Mode
• Stand-alone
Synchronization is turned off.This synchronization mode is used if the EK80
is working by itself and with no synchronization required. This is the default
setting. The EK80 operates using its internal ping interval parameters,
independent of any trigger signals arriving at the synchronization port.
The
Synchronization Delay
switched off.
• Master
Master mode is used if the EK80 is going to act as the controlling unit in a
synchronized system. The peripheral hydroacoustic system(s) are only permitted
to transmit when enabled by the EK80. When Master mode is selected, the EK80
will run using its internal ping interval parameters and send trigger signals to the
peripheral system(s).
This mode is unavailable if you set
Port.
• Slave
Slave mode is used if the EK80 is going to transmit only when permitted by a
peripheral system. When Slave mode is selected, the EK80 does not transmit
("ping") unless an external trigger appears on the chosen synchronization port.
The peripheral system may be any other hydroacoustic product (for example an
echo sounder or sonar), or even a dedicated synchronization system.
7 Select
Synchronization Delay
394149/D
menu.
Installation
dialog box opens. This dialog box contains a number
Installation
dialog box, select
Installation
.
setting is not applicable when synchronization is
.
.
Synchronization
Synchronization Port
Setting to work
.
to Transceiver Auxiliary
251