Kongsberg Simrad EK80 Installation Manual page 213

Observe that the
of pages selected from the menu on the left side.
2 On the left side of the
3 Install the channels(s).
a Observe that the transceiver(s) you have connected to the Processor Unit are
listed.
Each transceiver is identified with type and serial number. The available
channels on each transceiver are listed separately.
b For each channel, choose which transducer to connect to.
The list of transducers available for installation is defined by those you
installed on the
Note
This is a critical task. Make sure that the correct transducer is selected.
c At the bottom of the page, select
d Observe that the status for the relevant frequency channels change to Installed.
Tip
If no transceivers are listed:
1 Select in the
Browse
2 Select the correct address for the Ethernet adapter you are using. Select
This will make the EK80 search the network for available transceivers.
3 Turn each transceiver off and on.
The EK80 automatically assigns an IP address to each transceiver when they are
turned off and on.
Select .
Browse
4 Verify that the Ethernet communication between the units is operational.
5 If you are using an Ethernet switch, make sure that it works.
6 If you have changed the network settings, turn each transceiver off and on.
The EK80 automatically assigns an IP address to each transceiver when they are
turned off and on.
4 At the bottom of the page, select
5 Repeat until all the channels have been installed.
6 Continue your work in the
394149/D
dialog box opens. This dialog box contains a number
Installation
dialog box, select
Installation
page.
Transducer
Transceiver Browsing
Apply
Installation
Transceiver
to save your settings.
Apply
box, and open the
to save your settings.
dialog box, or select
Setting to work
.
box.
Local IP Address
.
Apply
to close it.
OK
211