Kongsberg Simrad EK80 Installation Manual page 47

Note
The installation shipyard must provide all necessary design and installation
drawings, as well as the relevant work standards and mounting procedures. If
required, all documents provided by the shipyard for the physical installation of
the EK80 must be approved by the vessel's national registry and corresponding
maritime authority and/or classification society. Such approval must be obtained
before the installation can begin. The shipowner and shipyard doing the installation
are responsible for obtaining and paying for such approval.
Relevant installation drawings are included with each transducer. The drawings
(normally in AutoCad format) can be downloaded from our website.
3 Install the EK80 system units.
Note that some EK80 system units may be commercial. Unless ordered specifically
these are not included in the delivery, and must be purchased locally.
• Installing the EK80 hardware units, page 64
4 Install the cables between the EK80 system units.
Observe the relevant cable plan, procedures, as well as the general requirements for
cabling. This is described in the Cable layout and interconnections chapter. Observe
the relevant cable plan, procedures, as well as the general requirements for cabling.
• Cable layout and interconnections, page 85
5 Install the cables between the EK80 and the relevant peripheral devices.
6 Turn on the EK80 for the first time, and set it to work.
Note
In order to turn on the EK80 in a safe and correct manner, the relevant procedures
must be complied to!
• Setting to work, page 185
7 Do a complete EK80 system test.
The tests are described in Setting to work chapter in this manual. They are also
provided in the Harbour Acceptance Test and the Sea Acceptance Test documents.
• Setting to work, page 185
Further requirements
Fill in and sign the Installation Remarks form, and send it to the Simrad support
department as specified on the form.
Related topics
Preparations, page 43
394149/D
Preparations
45