Kongsberg Simrad EK80 Installation Manual page 101

To learn more about the various video standards, explore these Wikipedia pages.
• DVI
• HDMI
• DisplayPort
4 Connect the cable from the Processor Unit to the keyboard. (C6)
5 Connect the cable from the Processor Unit to the mouse (or another similar device).
(C7)
6 Connect the Ethernet cable from the Processor Unit to the Wide Band Transceiver
(WBT). (C8)
Note
It is very important that a high-quality Ethernet cable is used. You must use
CAT-5E STP (Shielded Twisted Pair) quality or better. If you use a cable with
lower bandwidth capacity you will reduce the EK80 performance. Do not connect
the Processor Unit to the Wide Band Transceiver (WBT) using an existing local
area network (LAN).
Depending on the operational requirements, one or more Wide Band Transceiver
(WBT) units may be used in the complete EK80 system. An Ethernet switch is
required if more than one Wide Band Transceiver (WBT) is used.
For more information, see the cable details:
• RJ45 High speed Ethernet cable (1000Base-t), page 147
7 Connect the Ethernet cable from the Processor Unit to the local area network
(LAN). (C9)
For more information, see the cable details:
• RJ45 High speed Ethernet cable (1000Base-t), page 147
8 Connect the serial cables from the Processor Unit to the relevant external devices.
(C10)
For more information, see the cable details:
• Cable drawings and specifications, page 136
9 If applicable, connect the signal cable from the Processor Unit to the synchronization
system. (C10)
For more information, see the cable details:
• K-Sync interface to generic RS-232 synchronization input, page 148
• Simrad TU40 interface to generic RS-232 synchronization input, page 151
Related topics
Installing the EK80 cables, page 97
Cable layout and interconnections, page 85
394149/D
Cable layout and interconnections
99