Kongsberg Simrad EK80 Installation Manual page 272

Simrad EK80 Installation Manual
2 On the menu, select
Setup
3 On the left side of the
a If you use the motion sensor in the Motor Control Unit on the hull unit, make
sure that
LAN
The sensor uses a local area network (LAN) port on your Processor Unit. A
message on the page verifies that it is connected to the EK80 beamformer
application.
b If you use an external motion reference unit (MRU), make sure that a COM
port is selected, and that the correct parameters are provided.
4 On the left side of the
the page.
a Open the
MRU
b Make sure that the installation parameters for the motion sensor (offset and
rotation) are correct.
The physical location of the sensor (X, Y and Z offsets) must be extracted from
the detailed vessel drawings, or from the reports provided by the personnel that
did the actual installation. The information about the installation angles must
be extracted from the reports provided by the personnel that did or measured
up the actual installation.
5 Close the
Installation
6 Observe the top bar.
7 Make sure that the information from the sensor is displayed.
If necessary, enable the read-out in the
Note
In order to read the motion compensation values, the EK80 must be "pinging".
8 If possible, use another instrument to verify that the information provided by the
EK80 is correct.
9 Fill in the result tables.
Result
Port
270
.
Installation
dialog box, select
Installation
is selected.
dialog box, select
Installation
(Motion Reference Unit) page.
dialog box without making any changes.
Display Options
Baud rate
Motion Reference Unit
Installation Parameters
dialog box.
Protocol
.
to open
394149/D