Cc-Link Ie Tsn Wiring - Mitsubishi Electric MELSEC iQ-F FX5 Series User Manual

6.2

CC-Link IE TSN Wiring

This section describes the wiring when using CC-Link IE TSN.
Wiring methods
The following describes connection and disconnection of the Ethernet cable.
■Connecting the cable
1.
Power off the FX5-CCLGN-MS and the external device.
2.
Push the Ethernet cable connector into the FX5-CCLGN-MS until it clicks. Pay attention to the connector's direction.
3.
Lightly pull it to check that it is securely connected.
4.
Power on the FX5-CCLGN-MS and the external device.
5.
Check whether the LINK LED of the port connected with an Ethernet cable is on.
*1 The time between the Ethernet cable connection and the LINK LED turning on may vary. The LINK LED usually turns on in a few
seconds. Note, however, that the time may be extended further if the link-up processing is repeated depending on the status of the
device on the line. If the LINK LED does not turn on, refer to the following and take corrective actions.
Page 138 TROUBLESHOOTING
Both P1 connector and P2 connectors can be used.
• When only one of P1 and P2 connectors is used in a star topology, either P1 or P2 connector is applicable.
• When both ports are used in a line topology, P1-P1, P2-P2, and P1-P2 connections are acceptable.
■Disconnecting the cable
1.
Power off the FX5-CCLGN-MS.
2.
Press the latch down and unplug the Ethernet cable.
6 WIRING
86
6.2 CC-Link IE TSN Wiring
* 1