6.
Set the network configuration as follows. (Set the IP address for each station.)
[Navigation window] [Parameter] [Module Information] [FX5-CCLGN-MS] [Basic Settings] [Network
Configuration Settings]
7.
Click the [Close with Reflecting the Setting] button to close the "CC-Link IE TSN Configuration" window.
8.
Set the refresh settings as follows.
[Navigation window] [Parameter] [Module Information] [FX5-CCLGN-MS] [Basic Settings] [Refresh
Settings]
9.
In "Communication Mode" under "Application Settings", set "Unicast" or "Multicast".
[Navigation window] [Parameter] [Module Information] [FX5-CCLGN-MS] [Application Settings]
[Communication Mode]
10.
Click the [Apply] button.
11.
Write the set parameters to the FX5 CPU module on the master station. Then, reset the FX5 CPU module or power off
and on the system.
[Online] [Write to PLC]
In this example, default values are used for parameters that are not shown above. For the parameters, refer to
the following.
Page 89 PARAMETER SETTINGS
9.2 Communication Example between the Master Station and Local station
9 PROGRAMMING
115
9