5.2
Structure of Authentication Class B/A Devices and
Ethernet Devices
This section describes the system configuration when "Connection Device Information" under "Basic Settings" of the
engineering tool is set to "Mixture of Authentication Class B/A or Authentication Class A Only".
When "Connection Device Information" under "Basic Settings" of the master station is set to "Mixture of Authentication Class
B/A or Authentication Class A Only", up to 61 devices (1 master station and 60 slave stations) can be connected.
No.0
Class B (1Gbps)
General-purpose
switching hub
No.0: Master station
No.1: Local station
No.2, No.3, No.4, No.5, No.6: Remote station
(1), (2), (3): Ethernet device
Class A: Authentication Class A device
Class B: Authentication Class B device
The availability of connection of network configuration devices varies depending on the communication mode and
communication speed.
• Unicast mode
Page 75 When the communication speed for the master station is set to 1Gbps
Page 75 When the communication speed for the master station is set to 100Mbps
• Multicast mode
Page 76 When the communication speed for the master station is set to 1Gbps
Page 76 When the communication speed for the master station is set to 100Mbps
The following terms are used to describe the terms in the tables referenced.
(1)
No.0
5 SYSTEM CONFIGURATION
74
5.2 Structure of Authentication Class B/A Devices and Ethernet Devices
No.1
Class B (1Gbps)
No.4
Class A (100Mbps)
(1)
(2)
(2)
No.1
No.2
No.2
No.3
Class B (1Gbps)
Class B (1Gbps)
(3)
No.5
(100Mbps)
Class A (100Mbps)
No.0: Master station
No.1: Local station
No.2: Remote station
(1) Device on the master station side (The master station or a device near the
master station)
(2) Device on the end side (A device far from the master station)
(1)
(1Gbps)
General-purpose
switching hub
(2)
(100Mbps)
No.6
Class A (100Mbps)