Mitsubishi Electric MELSEC iQ-F FX5 Series User Manual page 27

Others
Function
"CC-Link IE TSN Parameter setting of a
Configuration" slave station
window
Detection of
connected/
disconnected devices
Parameter processing
of a slave station
Command execution
to slave stations
Reserved station setting
Error invalid station setting
Slave station parameter automatic setting
Station number/IP address setting using a
program
Description
Sets parameters of slave stations (the number of points and
assignment of link devices) in the master station.
Detects connected slave stations, and the stations are
displayed on the "CC-Link IE TSN Configuration" window.
Reads and saves the parameters from the slave station, and
writes the saved parameters to the slave station.
Executes commands (Error clear request, Error history clear
request) to a slave station.
Reserved stations are slave stations to be included among
the stations in the network for future extension and set in the
parameters. These stations are not connected to actual
networks, and are not regarded as faulty stations even if they
are not connected.
By setting a reserved station, link device assignment will not
change even if the slave station is connected (or the
reservation is cleared). Therefore, modification of the program
is not required.
An error invalid station is a slave station that is set to be not
detected as a faulty station by the master station. It is also set
when a slave station is to be replaced during data link.
Saves parameters of the slave station to the master station,
and sets the parameters automatically when the slave station
is connected or returned to the network.
Sets a station number and IP address to the own station
which has no station number and IP address setting using a
program. This function allows project data items of stations
with the same program and network parameters (excluding
the station numbers and IP addresses) to be the same,
leading to reduced development work hours.
Availability Reference
Master Local
station station
 
Page 100
Parameter
setting of a slave
station
  Page 102
Connected/
Disconnected
module detection
 
Page 104
Parameter
processing of a
slave station
  Page 106
Command
execution to
slave stations
 
Page 100 "CC-
Link IE TSN
Configuration"
Window
 
Page 100 "CC-
Link IE TSN
Configuration"
Window
  Page 63 Slave
station parameter
automatic setting
 
Page 107 Other
dedicated
instructions
4 FUNCTIONS
4.1 Function List
4
25