Isuzu D-MAX 2020 Owner's And Driver's Manual page 778

6-102
SERVICE AND MAINTENANCE
Wiper Blade Replacement (Flat Blade Type)
Service position
To replace the wiper blade, switch the
wiper in the service position.
ADVICE
• Check that the engine hood is
securely closed.
Engine Hood → Refer to page 6-11
Switching the Wiper between the
Service Position/Normal Position
1. Make sure that the windshield wiper
RTUL60SH009601
switch is in the "OFF" position.
Windshield Wiper Switch
2. Switch the power mode to "ON", and
immediately to "OFF" (models with
passive entry and start system), or
turn the starter switch to the "ON"
position, and immediately to the
"LOCK" position (models without
passive entry and start system).
3. Pull up and hold the windshield
washer switch to switch the wiper
position.
Windshield Washer Switch
• For approximately 1 minute after
performing the operation mentioned
in step 2, it is possible to switch the
wiper position.
→ Refer to page 4-131
→ Refer to page 4-136
NOTE