Isuzu D-MAX 2020 Owner's And Driver's Manual page 709

Oil change is needed
Inspection
MAX
1
Replenishment
MAX
2
MIN
Adding oil is needed
Front Back Front Back
SERVICE AND MAINTENANCE
• The dirt and oil on the following
parts must be wiped off before
reinstalling the oil pan drain plug.
- Thread of the oil pan drain plug
- Thread of the oil pan drain hole
- Bolt seat surface of the oil pan
25. Measure the specified quantity of the
specified oil.
26. Pour the specified quantity of oil once
from the oil filler.
27. Install the oil filler cap.
28. Wait 5 minutes or more without
starting the engine.
29. Remove the oil dipstick and wipe off
any oil on the oil dipstick.
30. Reinsert the oil dipstick fully and then
gently remove it.
31. Check the front and back of the oil
dipstick. If the highest position is
higher than the "MIN" mark, the oil is
at the correct level.
- If the "Replenishment MAX" mark
is exceeded, drain oil until the
level is between the "MIN" and
"Replenishment MAX" marks (range
2).
32. Reinstall the oil dipstick into position
after checking the oil level.
RTUL60SH010701
MIN
RTUL60SH011401
ADVICE
6-33