Isuzu D-MAX 2020 Owner's And Driver's Manual page 333

NOTE
• When the ESC warning light is on, the TCS/ESC will not operate, but this has
no effect on normal driving.
• The ESC warning light may come on when the battery cables are disconnected
or the battery voltage is low. The ESC function turns off while the ESC warning
light is on, but the ESC warning light will turn off by driving the vehicle normally
for a while, then the ESC function will resume. If the ESC warning light remains
on even after driving for a while, contact the nearest Isuzu Dealer.
CONTROLS AND INSTRUMENTS
ESC Warning Light
This warning light comes on whenever
there is a problem in the electronic stability
control (ESC) and/or hill descent control.
When the ESC is operating, this warning
light flashes.
This warning light also comes on when the
4WD switch is set to 4L (4WD low).
This warning light will also flash when
only the traction control system (TCS)
function is operating inside the ESC
system.
When the ESC warning light does any
of the following, the ESC may be faulty.
Please contact the nearest Isuzu Dealer.
• When the ESC warning light remains
• The ESC warning light does not come
Electronic Stability Control (ESC)
Hill Descent Control
on while driving.
on when the power mode is switched
to "ON" (models with passive entry
and start system) or the starter switch
is turned to the "ON" position (models
without passive entry and start
system).
→ Refer to page 4-164
→ Refer to page 4-175
4-57