Isuzu D-MAX 2020 Owner's And Driver's Manual page 485

WARNING (Continued)
- When there are curbstones in the direction the vehicle is moving.
- When driving on an uneven road.
- When mud, snow, ice, and/or other similar substances are on the sensors or
around the sensors.
- When the sensors or areas around the sensors are blocked.
- When a strong impact applied to the sensors or around the sensors misaligns
the position or direction of the sensors.
- When the vehicle is on an undulating, inclined, gravel, or rough road, or in
bushes.
- When something that generates high-frequency sounds, such as the horn
sound of another vehicle, the engine sound of a motorbike, the air brake noise
of a large-sized vehicle, or something that generates ultrasonic waves, such
as the sensor of another vehicle, is nearby.
- When an obstacle is too close to the sensors.
• There is a delay after an obstacle is detected before the buzzer sounds and
the detection status is displayed on the MID. Even when the vehicle speed is
extremely low, the vehicle may approach the obstacle before the buzzer sounds
and the detection status is displayed on the MID.
• Depending on the shape and/or conditions of the obstacle, even after an
obstacle has been detected once, the system may not detect the obstacle after
approaching it.
• When you drive your vehicle in reverse while your vehicle is towing another
vehicle, the rear sensors may react to the vehicle being towed, causing the
warning to remain on. Therefore, set the parking aid system mode as follows
before towing another vehicle.
- When only a trailer hitch is mounted: Trailer hitch only
- When towing another vehicle: Off
CONTROLS AND INSTRUMENTS
Trailer Mode/Bull Bar Mode
4-209
→ Refer to page 4-216