Isuzu D-MAX 2020 Owner's And Driver's Manual page 332

4-56
CONTROLS AND INSTRUMENTS
CAUTION
• If the ABS warning light comes on while driving, immediately stop your vehicle
at a safe place well clear of traffic and take the following actions.
- Stop the engine.
- Restart the engine. Check if the ABS warning light comes on and then goes
out. If it does, there is no problem. The ABS operates normally.
- Move the vehicle slowly forward. Gradually increase the speed to 15 km/h (9
MPH). If the light goes off, the ABS is normal.
• Immediately stop your vehicle at a safe place and contact your Isuzu Dealer
when the ABS warning light and brake system warning light both remain on.
The indications mean that the ABS will fail and vehicle will become extremely
unstable during braking. Also the rear brakes may lock up more easily than
usual in emergency braking. This could result in an accident.
• If the ABS warning light does not go out, or comes on repeatedly, have the
vehicle inspected/serviced at the nearest Isuzu Dealer as soon as possible.
• Even if a problem has occurred in the ABS, the brakes will still work as normal
brakes. In this case, the ABS has no influence on the operation of the brake
system.
ABS Warning Light
This warning light comes on whenever
there is a problem in the anti-lock brake
system (ABS). In this case, the ABS stops
working but the brakes still function as
ordinary service brakes.
This warning light also comes on when the
rear differential lock switch is "ON" (models
with rear differential lock).
Anti-lock Brake System (ABS)
→ Refer to page 4-159