Isuzu D-MAX 2020 Owner's And Driver's Manual page 155

PRE-DRIVING OPERATIONS AND ADJUSTMENTS
Key with Immobilizer Transponder Chip
WARNING
• No alterations or additions should be made to the immobilizer system, as
such alterations or additions would automatically invalidate the certificate of
installation.
The immobilizer key and electronic key contain an immobilizer transponder chip.
The immobilizer anti-theft system allows the engine to be started only when it receives
signals from the transponder of the pre-registered key.
NOTE
• In models with passive entry and start system, the electronic key contains a
transponder chip, and when the electronic key battery goes flat, the power
mode can be changed and the engine can be started through verification of
the transponder chip. Refer to "When the Electronic Key Battery Goes Flat" for
details.
• In models without passive entry and start system, when the starter switch
is turned to the "ON" position, verification of the transponder chip will be
performed. If the verification is successful, it will become possible to start the
engine. Also, after the starter switch is turned from the "ON" position to the
"ACC" or "LOCK" position and a maximum of approximately 30 seconds has
passed, it will be necessary to perform verification again in order to start the
engine.
Engine Start/Stop Button (Models with
Passive Entry and Start System)
→ Refer to page 4-112
Starter Switch (Models without Passive
Entry and Start System)
→ Refer to page 4-115
When the Electronic Key Battery Goes
Flat → Refer to page
3-5
7-7