Isuzu D-MAX 2020 Owner's And Driver's Manual page 384

4-108
CONTROLS AND INSTRUMENTS
Warning
Shift position
(models with
passive entry and
start system)
Turn off the power
(models with
passive entry and
start system)
Low battery
electronic key
(models with
passive entry and
start system)
Check system
(models with
passive entry and
start system)
Power
management
system
(models with
passive entry and
start system)
Buzzer pattern
Continuous beep
(external buzzer)
Short repeated beeps
(in-vehicle buzzer)
Three repeated beeps
(in-vehicle buzzer)
Three repeated beeps
(in-vehicle buzzer)
Three repeated beeps
(in-vehicle buzzer)
Short beep
(external buzzer)
Three repeated beeps
(in-vehicle buzzer)
Three repeated beeps
(in-vehicle buzzer)
Continuous beep
(in-vehicle buzzer)
Short beep
(external buzzer)
Continuous beep
(external buzzer)
Three repeated beeps
(in-vehicle buzzer)
Condition
If the electronic key is carried outside the
vehicle and then the doors are closed
with the power mode in the "OFF" and the
selector lever in a position other than "P"
(automatic transmission model).
If the selector lever is moved to a position
other than "P" with the driver side door open
(automatic transmission model).
If starting of the engine is attempted
by pushing the engine start/stop button with
the selector lever in a position other than "P"
or "N" (automatic transmission model).
If starting of the engine is attempted
by pushing the engine start/stop button with
the gearshift lever in a position other than "N"
(manual transmission model).
If an attempt to switch the power mode from
"ON" to "OFF" is made with the selector
lever in a position other than "P" (automatic
transmission model).
If door locking is attempted by pressing the
request switch on the door handle or the lock
button on the electronic key with the power
mode is in "ON" or "ACC".
If the battery voltage of the electronic key is
low when the power mode is switched from
"ON" to "OFF" (or "ACC").
If an error occurs to the passive entry and
start system when door locking is attempted
by pressing the request switch on the door
handle or by pushing the engine start/stop
button.
If an error occurs to the power management
system when the engine start/stop button is
pushed.