Isuzu D-MAX 2020 Owner's And Driver's Manual page 407

Windshield Wiper and Windshield Washer Switch
Windshield wiper and
windshield washer switch
ADVICE
• Clear ice or packed snow from the wiper blades before using the wipers.
• Before operating the wiper, ensure that the wiper rubber is not stuck on to the
windshield. If the wiper rubber is stuck to the windshield and you still operate
the wiper, the wiper may break or the wiper motor may fail.
• Do not operate the wiper on a dry windshield surface. Otherwise, the windshield
surface may sustain damage. Always use the windshield washer when wiping a
dry glass surface.
• The safety system may work to stop the wiper when excessive load is applied
on the motor. In this case, turn the switch to the "OFF" position and, a few
minutes later, check to see if the wiper is back to normal operation. If the wiper
frequently stops operation, refrain from using it and contact the nearest Isuzu
Dealer.
CONTROLS AND INSTRUMENTS
The windshield wiper and windshield
washer switch is located at the position
shown in the diagram.
To use the windshield wiper and washer
switches, the power mode must be "ON"
(models with passive entry and start
system) or the starter switch must be in
the "ON" position (models without passive
entry and start system).
Windshield Wiper Switch
RTUL40SH044301
4-131