Replacing The Power Supply Module - Christie Boxer 4K Series Service Manual

Left Side
Top B1
Middle B2
Bottom B3
B1
B2
B3
8. Remove two screws from the stack of the lamp drivers that contains the one to be replaced.
9. Disconnect the two harnesses.
10. Slide it to the side to remove the driver.
11. Disconnect the third harness.
12. The lamp driver module comes out as a stack.
13. Remove the failed lamp driver.
14. Install the new lamp driver.
15. To reassemble the projector, follow these steps in reverse order.

Replacing the power supply module

The power supply module provides the required voltages for operating the electronics in the projector.
Estimated replacement time: 10 minutes
Boxer 4K Service Guide
020-101699-04 Rev. 1 (02-2018)
Copyright 2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Right Side
A1
A2
A3
A1
A2
A3
Electronics
66