Replacing the lamp driver
Each lamp driver provides the energy required to drive one lamp module in the projector.
Estimated replacement time: 10 minutes for servicing a single lamp driver
1. Remove the top cover (on page 34).
2. Remove the rear cover (on page 35).
3. Disconnect the four connections to the lamp driver, J70, J78, the lamp driver power inline, and
the lamp cartridge inline.
4. Loosen the four captive screws from the top of the lamp driver module.
5. Pull the lamp driver module out the rear of the projector.
6. Remove the three screws to open the lamp driver housing cover.
7. Locate the lamp driver to replace.
Boxer 4K Service Guide
020-101699-04 Rev. 1 (02-2018)
Copyright
2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Electronics
65