Christie Boxer 4K Series Service Manual page 76

16. Pull the light engine towards yourself at a 45 degree angle to clear the pins on the
convergence interface plate and then pull it completely out.
When removing or replacing the light engine, ensure special care is taken around the red
formatter board and the fan duct. If you do not lift light engine straight out or replace it
straight in, the formatter board may contact the fan duct, which can disable the red formatter
board.
17. Place the light engine on the shipping base plate.
18. To secure the light engine to the shipping base plate, tighten the two screws.
19. Put the light engine and base plate in the shipping package and return to Christie.
20. To re-install the new light engine, follow these steps in reverse order.
When re-installing the light engine into the projector, avoid pinching the green fan harness and
contacting the red satellite board on the firewall.
Boxer 4K Service Guide
020-101699-04 Rev. 1 (02-2018)
Copyright 2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Optics
76