Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Christie Manuals
  4. Projector
  5. boxer 4K30
  6. Manual

Christie Boxer 4K30 Manual

Installing the boxer harness connector backplates
Hide thumbs Also See for Boxer 4K30:
1
2
3
4
5
6
7

Advertisement

Quick Links

Download this manual
Installing the Boxer
harness connector
backplates
To secure the lamp driver harness connectors to prevent damage to the connectors, install the Boxer
Harness Connector kit.
Affected products
The following products are affected:
•
Boxer 4K30
•
Mirage 304K

Parts list

The following parts are required for the installation of the Boxer harness connector backplates.
•
003-005514-XX

Tools required for installation

Make sure the following tools are available during the installation.
•
Long and stubby neck magnetic-tip ball drivers—2.5 mm, 3 mm, and 5 mm provided in
projector toolbox
•
Needle nose wire cutter
Installing the Boxer Harness Connect Backplates Instruction Sheet
020-102015-01 Rev. 1 (10-2015)
1

Advertisement

loading

Related Manuals for Christie Boxer 4K30

Summary of Contents for Christie Boxer 4K30

  • Page 1: Parts List

    To secure the lamp driver harness connectors to prevent damage to the connectors, install the Boxer Harness Connector kit. Affected products The following products are affected: • Boxer 4K30 • Mirage 304K Parts list The following parts are required for the installation of the Boxer harness connector backplates.

  • Page 2: Safety Precautions

    EXPLOSION HAZARD! Allow sufficient time for the lamp to cool down before powering down the product, disconnecting it from AC, and opening the lamp door. • All procedures must be performed by Christie qualified technicians. • Use protective eye wear and gloves when cleaning and servicing the product. Follow workplace guidelines for using personal protective equipment when cleaning and servicing products.

  • Page 3: Removing The Rear Cover

    Installing the Boxer harness connector backplates 1. Loosen the six captive screws securing the top cover. 2. Remove the top cover. 3. To install the top cover, repeat these steps in reverse order. Removing the optics-side cover The optics-side cover provides access to liquid cooling module, integrator focus module, zoom/focus module, NFC readers, and other components.
  • Page 4 Installing the Boxer harness connector backplates 1. Loosen the six captive screws securing the rear cover. 2. Remove the rear cover. 3. To install the rear cover, repeat these steps in reverse order. Removing the integrator module The integrator module is positioned between the two lamp cartridges and captures light from up to six lamps and combines it into a uniform rectangular light source for the light engine.
  • Page 5 Installing the Boxer harness connector backplates 7. To free the lamp blower fan pack, remove the screw securing it. 8. Disconnect the J73 and J74 harnesses. 9. Free the harnesses from the clips. 10. Remove the lamp blower fan pack. 11.
  • Page 6 Installing the Boxer harness connector backplates 19. Remove the two screws from the bottom of the integrator focus module to disengage it from the bottom of the projector. 20. Remove the four screws from the front of the integrator focus module connecting it to the zoom and focus module.
  • Page 7 Installing the Boxer harness connector backplates 2. Install the two harness connector backplates (011-106859-XX) to the integrator front bracket using the mounting holes as shown. Installing the Boxer Harness Connect Backplates Instruction Sheet 020-102015-01 Rev. 1 (10-2015)

This manual is also suitable for:

Mirage 304k