Printed circuit boards
and sensors
Printed circuit boards (PCB) mechanically support and electrically connect to the projector
components. Sensors convert information such as temperature, light, and communication into
electrical signals.
Replacing the IMXB board
The IMXB module acts as the communication interface between the projector and the control systems.
Estimated replacement time: 30 seconds
1. Loosen the two captive screws and pull out the IMXB board.
2. Replace the IMXB board.
3. To re-install, follow these steps in reverse order.
Replacing the high-speed imaging processing
board (HIP)
The high-speed imaging processing board (HIP) provides the signal processing of the inputs going into
the projector.
Estimated replacement time: 13 minutes
Boxer 4K Service Guide
020-101699-04 Rev. 1 (02-2018)
Copyright
2018 Christie Digital Systems USA, Inc. All rights reserved.
©
99