4. Replace the RTSM.
5. To re-install, follow these steps in reverse order.
Replacing the manual focus sensor
The manual focus sensor detects if focus is being adjusted manually and prohibits any automatic focus
adjustments.
Estimated replacement time: 21.5 minutes
1. Remove the lens boot (on page 87).
2. Remove the lens mount barrel (on page 87).
3. Remove the two screws securing the manual focus sensor.
4. Route the harness from the clip.
5. Cut the cable ties to remove the harness.
6. Disconnect the manual focus sensor.
7. Remove and replace the manual focus sensor.
8. To re-install, follow these steps in reverse order.
Boxer 4K Service Guide
020-101699-04 Rev. 1 (02-2018)
Copyright
2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Printed circuit boards and sensors
109