1. Remove the top cover (on page 34).
2. Remove the optics-side cover (on page 35).
3. Remove the light dump (on page 72).
4. Remove the rear cover (on page 35).
5. Remove the user interface module (on page 60).
6. Open the AC input module.
7. Remove the two screws securing the mini-SAS bracket.
8. Disconnect the three mini-SAS harnesses from the card cage.
9. Disconnect the harnesses to the housekeeping (HKBA) board.
The J92, J30, J117, J77, J87, J88, and J5 harnesses run across the mini-SAS harnesses.
10. Disconnect the shutter harness.
11. Loosen the captive screw for the laminar airflow device (LAD) housing assembly.
Boxer 4K Service Guide
020-101699-04 Rev. 1 (02-2018)
Copyright
2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Optics
74