Christie Boxer 4K Series Service Manual page 71

1. Remove the lamp module (on page 70) that contains the lamp to be replaced.
2. Remove the two screws securing the lamp grills from the bottom of the lamp cartridge.
3. Remove the four screws from the lamp lens mounting bracket.
4. Remove the two grills.
5. Remove the reflector duct.
6. Remove the grill spacer.
7. Remove the lens mounting bracket.
8. Remove the lens.
9. Make sure the curved side (convex side) of the lens is pointing out when you remove the lens.
10. Replace the lens.
11. Replace the lens mounting bracket, making sure the bracket tabs are pointing up.
12. Tighten the four screws on the lens mounting bracket.
13. Replace the grill spacer with the grill in place on the side of the lamp IDs and tighten the
screws.
14. Replace the reflector duct with the grill in place on the opposite side of the lamp IDs and
tighten the screw.
15. Re-install the remaining components.
Boxer 4K Service Guide
020-101699-04 Rev. 1 (02-2018)
Copyright 2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Optics
71