d) Remove the SLB harness.
e) Replace the SLB harness.
5. To install the new HKB and SLB harnesses, repeat these steps in reverse order.
Replacing the lamp driver harnesses
The lamp driver harnesses connect the lamp driver module to the housekeeping (HKBA) board.
Estimated replacement time: 18 minutes
1. Remove the integrator module (on page 77).
2. Disconnect the two lamp driver harnesses from the integrator lamp cartridge bracket.
3. Remove the two tension clips around the lamp driver harnesses.
4. Disconnect the lamp driver harnesses from the power connection.
5. Disconnect J89 from the HKBA.
Boxer 4K Service Guide
020-101699-04 Rev. 1 (02-2018)
Copyright
2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Harnesses
96