1. Remove the front filter doors (on page 31).
2. Using a M4 screwdriver, remove the six screws securing the front cover.
3. Remove the front cover.
4. If required, replace the front cover.
5. To install the front cover, repeat these steps in reverse order.
The lens boot must be properly re-aligned before securing the front cover.
Removing the top cover
The top cover provides access to the light engine, HKBA board, and various other components.
Estimated replacement time: 1 minute
1. Loosen the six captive screws securing the top cover.
2. Remove the top cover.
3. If required, replace top cover.
4. To install the top cover, repeat these steps in reverse order.
Boxer 4K Service Guide
020-101699-04 Rev. 1 (02-2018)
Copyright
2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Projector covers and feet
34