Replacing the auto focus sensor
The auto focus sensor detects the position of the focus barrel.
Estimated replacement time: 19.5 minutes
1. Remove the lens boot (on page 87).
2. Remove the lens mount barrel (on page 87).
3. Remove the screw securing the auto focus sensor.
4. Disconnect the inline connector.
5. Remove and replace the auto focus sensor.
6. To re-install, follow these steps in reverse order.
Replacing the vertical and horizontal offset
adjust sensor
The vertical and horizontal focus adjust sensors detect any vertical or horizontal offset adjustments.
Estimated replacement time: 5.5 minutes
Note the location of the vertical and horizontal offset adjust sensors:
•
Vertical offset adjust sensor
•
Horizontal offset adjust sensor
Boxer 4K Service Guide
020-101699-04 Rev. 1 (02-2018)
Copyright
2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Printed circuit boards and sensors
110