Mitsubishi Electric GOT1000 Series Connection Manual page 30


About system configuration
The following describes the system configuration of each connection included in this manual.
The configuration of The configuration of The configuration of
equipment connected equipment connected equipment connected
to GOT is shown. to GOT is shown. to GOT is shown.
QCPU
Indicates the connection diagram
number of cables to be prepared by
the user.
Refer to the connection diagram
section in each chapter.
Indicates the commercially available
cable models that can be used.
Since the above page was created for explanation purpose, it differs from the actual page.
A - 28
The cable connecting The cable connecting The cable connecting
the GOT to the the GOT to the the GOT to the
equipment is shown. equipment is shown. equipment is shown.
RS-422 connector
conversion Cable
Connection cable
Indicates the maximum distance between
the PLC and GOT.
System Configuration Examples System Configuration Examples System Configuration Examples
(When connecting the PLC [MELSEC-Q] and GT16, with RS-422 cable)
1) Connect the RS-422 conversion cable [FA-CNV2402CBL] to the [MELSEC-Q].
2) Connect the option [GT16-C02R4-9S] to [GT16].
3) Connect [MELSEQ-Q] and [GT16] with the connection cable [GT01-C30R4-25P].
The configuration of The configuration of The configuration of
the GOT connected to the GOT connected to the GOT connected to
equipment is shown. equipment is shown. equipment is shown.
For the option devices,
refer to the following.
1.3 Option Devices
for the Respective
Connection
GOT
A representative example
of the system configuration
is described with an
illustration.