Chapter 4 Description of Functions
Initialize: Returns to the default value if unexpected operation occurs due
Save:
(3) Controller connection status
Press the connection status change button to change the communication status
of the HL-D3C. Switch the button to online (or monitoring) to enable change
of the HL-D3C set value.
"Offline":
"Online":
4
"Monitoring":
* In online, the model information of the HL-D3C can be obtained, but the
setting information cannot be obtained.
To obtain the setting information, press the "LOAD" button.
To obtain the setting information at the time of online, select "Menu" →
"System" → "System settings" and check "Apply controller sets when
online and at initialization".
Without this operation, the set value in the sensor is not
changed.Immediately after SEND, the sensor is unfixed.
to incorrect settings.
Execute this when all set values of the sensor items are determined.
Status not connected to the HL-D3C (USB communication close)
Communication with the HL-D3C is available, but the measurement
operation is in stop (laser OFF).
Various setting change, detection image check, buffering, etc. can be
executed.
It is connected to the HL-D3C and continuous measurement is in op-
eration (laser ON).
(Display in black)
(Display in red)
(Display in red)
4-32